ADJUSTING DEVICES
- hikmahhusaini
- Sep 2, 2017
- 1 min read
TURNBUCKLES/TURNBARRELS

~ Control cable rigging is is adjusted by using turnbuckles
~ The bronze barrel has right hand threads in one end and left
hand threads in other hand
~ The groove around one end and of the turnbuckle barrel is
identified has left-hand thread
~ The cable terminal ends are screwed onto the barrel and as
it is turned, it pulls the ends into it ~ There must be MORE THAN THREE threads exposed on
either end of the barrel to PRODUCE FULL STRENGTH
LOCKING METHODS of TURNBUCKLES ~ When the cable system is properly adjusted, the turnbuckles
must be secured
~ Different locking methods are used to prevent the barrels
from turning;
•Wire locking method
•Clip locking method
!!!!!! Due to the simple installation procedure, the clip locking method has replaced the wire locking method in wide range

CLIP LOCKING

Comments